Trouble Shooting
Filter cleaning Procedures
- Unplug GFCI plug from wall outlet / receptacle
- Place 3 caps over two suction and one water return fittings in spa.
- Turn filter lid retaining lock lid counter clock wise and remove, remove filter lid, lift out and remove filter cartridge.
- With high pressure garden hose nozzle, spray at a 45 degree downward direction in between each pleat all the way
around filter. For best results soak in a spa filter cleaner (available at most pool, spa, or hardware / home stores).
Just rinsing in the sink will NOT do the job. Let dry before replacing.
- Place filter back into filter tank. Make sure rubber o-ring is seated in place around perimeter of filter housing top groove.
- Place filter lid on tank, thread on filter lid retaining lock clockwise until snug. Hand tight only. Do not cross - thread.
- Remove 3 caps from inside spa suction & return fittings.
- Open air bleeder valve counter-clockwise until water spews out, then close clock-wise.
- Plug GFCI back into wall outlet. Verify there is good water flow by placing hand in front of water returns inlet ( lower
fitting on spa wall). If good flow detected, set thermostat to desired temperature and replace cover.
